Pressure washing in Riverside & Redlands.
Inland Empire sun bakes dirt, tire marks and irrigation staining into concrete. We cut it back to a bare, bright surface with up to 4,000 PSI and the right detergent for the surface — driveways, patios, walkways, pool decks, parking lots and apartment communities.
Proudly serving Riverside, San Bernardino, Redlands and Corona and every city across the Inland Empire.

Hard surfaces, handled right.
Pressure is a tool, not a setting we leave wide open. Every surface below gets its own nozzle, pressure and detergent mix.
Swipe or scroll
Riverside and Redlands are not the same job.
Riverside concrete, renewed.
Clay soil, summer dust and hard irrigation water leave Riverside concrete gray, streaked and slick. From the Wood Streets and Arlington to Canyon Crest, Orangecrest and downtown, we bring driveways, walks and patios back to the color they were poured at — including the apartment communities and storefronts that carry the most foot traffic.
All services in RiversideWhat we wash here
- Degreaser pre-treat lifts oil, grease and transmission stains on driveways
- Stamped and colored concrete cleaned without etching the sealer or dye
- Apartment buildings, carports and breezeways washed on a schedule
- Downtown and University Avenue storefronts cleaned before open
Redlands concrete, renewed.
Redlands has brick, stone and older concrete that reward a careful hand — no etching, no blown joints, no pitted mortar. From the historic districts and downtown to the newer builds pushing out toward Yucaipa, we match pressure and method to what the surface was actually made of.
All services in RedlandsWhat we wash here
- Brick paver drives and historic masonry washed, joints left intact
- Citrus-grove dust and valley dirt flushed from walks and patios
- Pool decks and patio stone cleaned at low, controlled pressure
- Downtown Redlands storefronts and restaurant patios maintained year-round
Four steps, in this order.
Step 01
Assess
We test the surface and check for cracks, loose mortar or failed sealer before water ever hits it.
Step 02
Pre-treat
Degreaser and detergent go down first, so the grime releases instead of being driven into the concrete.
Step 03
Surface clean
Up to 4,000 PSI, run through a surface cleaner for an even, stripe-free finish.
Step 04
Rinse & inspect
Everything rinsed, landscaping protected, and we walk it with you before we pack up.
Straight answer: we don't pressure wash roofs, painted siding or drywall. Those get a low-pressure soft wash — high pressure would damage them. If that's your job, we'll say so and quote the right method.
What it runs.
Starting prices for the work most Riverside and Redlands homeowners ask for. Two-story homes typically run about 35% more. Nothing gets added after the fact.
Driveways & walkways
From $199
Single-car drive, front walk, apron
Full pressure washing
From $249
Driveway, walks, patios and rear concrete
Patios & pool decks
Quoted by size
Stamped, pavers and stone priced separately
Commercial & apartment
Custom quote
Priced per square foot, scheduled as needed
Real jobs, before and after.
Pressure washing questions.
How much does pressure washing cost in Riverside or Redlands?
Most residential pressure washing starts at $249, and driveways and walkways start at $199. Two-story or oversized properties typically run about 35% more, and commercial lots and apartment communities are quoted by square footage. Every estimate is free — call 909-403-1552.
What's the difference between pressure washing and soft washing?
Pressure washing uses high-pressure water on hard surfaces like concrete, pavers and masonry. Soft washing uses low pressure with biodegradable detergent for roofs, stucco, siding and anything delicate. We match the method to the material so nothing gets etched or damaged.
Can you remove oil stains from a driveway?
A degreaser pre-treat and controlled pressure lift most oil, transmission fluid and tire marks. Deep, years-old oil can lighten dramatically but may not disappear completely. We tell you what to expect on your surface before we start, not after.
Do you pressure wash roofs?
No. Roofs get a low-pressure soft wash instead — high pressure strips asphalt shingle granules and can crack tile. If your roof is streaked black, that's algae, and soft washing is the correct fix.
Which areas around Riverside and Redlands do you cover?
We serve Riverside and Redlands plus Corona, Moreno Valley, Norco, Eastvale, Loma Linda, Grand Terrace, Colton, Yucaipa and the rest of the Inland Empire.
How long does a pressure washing job take?
A driveway and front walk typically takes two to three hours. A full property with patios, pool deck and fencing usually runs most of a day. You get a time window with your quote.
Get your concrete back.
Free on-site estimate in Riverside, Redlands and across the Inland Empire. Call now or request a quote online — we'll tell you exactly what your surface needs.


